Emergency Epoxy resine 200 bar resistance fixer epoxy

The product shown in the image is the YED Leeward Marine Grade Resin Patch Set, which is used in the shipbuilding and maritime industry to stop leaks and repair pipelines. It is a high-strength epoxy system specifically designed for emergency repairs.

The technical specifications and areas of use of this set are as follows:

Product Details and Capacity

• Contents: 810 g Resin + 140 g Hardener (Total 950 g)

• Temperature Resistance: Withstands temperatures up to 180°C (356°F), making it suitable for hot water and steam lines.

• Approval: Approved by Phoenix Register of Shipping (compliant with maritime standards).

Areas of Use

This set is commonly used for repairing the following systems on ships:

• Hydraulic Pipes: Patching cracks and holes in high-pressure hydraulic circuits.

• Fuel and Oil Lines: Rapid sealing of leaks.

• Fresh and Seawater Pipes: Repairing perforations caused by corrosion.

• Exhaust and Steam Lines: Can also be preferred for these systems thanks to its high temperature resistance.

Application Tips

To achieve maximum efficiency from such products, pay attention to the following steps:

• Surface Preparation: Thoroughly clean the application area from oil, rust, and dirt. Sanding the surface increases the adhesion strength of the resin.

• Mixing Ratio: Mix the 810 g resin and 140 g hardener thoroughly until a homogeneous mixture is obtained.

• Curing Time: The curing time may vary depending on ambient temperature. Avoid applying high pressure to the pipe until full curing is achieved.

• Reinforcement: For larger holes, applying the resin in layers together with fiberglass mats will increase the strength of the patch.

⚠️ Caution: Since hydraulic systems operate under very high pressure, it is vital to recommission the system in a controlled manner after the patching process and to closely monitor for any leaks.